Mason 3D

Enter my La Bo Ra To Ree

Menu

Skip to content
  • Home

Monthly Archives: November 2015

Fine tune bed height in Marlin while you are printing

While I enjoy using my 3d printer there’s one chore that I hate doing over and over again. Leveling my print bed and adjusting the print height! I even have an auto bed leveling setup with an inductive probe, but I still find it necessary to tweak the height of the bed to get the…

November 2, 2015 in Uncategorized.

Reduce slop on your Corexy 3d printer with eccentric spacers

After using my C-bot for a while I’ve always been a little frustrated that I can’t keep the mini V wheels all tightly aligned to the rails. Usually I can freely turn one of the four wheels which means that every wheel is not tight against the rail. The original C-Bot printer design uses little…

November 2, 2015 in Uncategorized.

Recent Posts

  • Cutting the beams for your cubic foot C-Bot 3d printer
  • Fine tune bed height in Marlin while you are printing
  • Reduce slop on your Corexy 3d printer with eccentric spacers
  • Light up your world: Add RGB Lighting to your Rumba based 3d printer
  • Printing a printer: Core Bot Part 2

Archives

  • December 2015
  • November 2015
  • June 2015
  • May 2015
  • September 2013

Categories

  • Core Bot
  • Uncategorized

Meta

  • Log in
  • Entries RSS
  • Comments RSS
  • WordPress.org
Proudly powered by WordPress | Theme: Expound by Konstantin Kovshenin